Your Privacy Choices

As described in our Privacy Policy, we collect personal information from your interactions with us and our website, including through cookies and similar technologies. We may also share this personal information with third parties, including advertising partners. We do this in order to show you ads on other websites that are more relevant to your interests and for other reasons outlined in our privacy policy.

Sharing of personal information for targeted advertising based on your interaction on different websites may be considered "sales", "sharing", or "targeted advertising" under certain U.S. state privacy laws. Depending on where you live, you may have the right to opt out of these activities. If you would like to exercise this opt-out right, please follow the instructions below.

If you visit our website with the Global Privacy Control opt-out preference signal enabled, depending on where you are, we will treat this as a request to opt-out of activity that may be considered a “sale” or “sharing” of personal information or other uses that may be considered targeted advertising for the device and browser you used to visit our website.

Step 1: Fill the Cup

Add tap water or drinking water to the stainless steel cup until the water reaches the MIN line. Place the cup on a flat surface and avoid filling above the marked line.

Step 2: Insert the Silicone Mold

Gently place the silicone mold into the cup. Press it down slowly and evenly until it is fully seated. A small amount of water may come out through the vent opening during this step.

Step 3: Freeze for 18+ Hours

Place the assembled mold upright on a flat surface in the freezer. Freeze for at least 18 hours. A longer freezing time may be needed depending on the freezer temperature and how often the freezer door is opened.

Step 4: Remove the Silicone Mold

Take the mold out of the freezer. Hold the stainless steel cup securely and carefully pull the silicone mold out of the cup. Do not twist or force it excessively.

Step 5: Let the Mold Rest

Leave the silicone mold at room temperature for about 2 minutes. This allows the outside of the ice to loosen slightly, making the mold easier to open.

Step 6: Open the Mold

Gently open the silicone mold and remove the clear ice ball. Slight bubbles, minor cloudiness, or a small opening at the bottom of the ice ball may occur and are normal.