プライバシー設定

弊社のプライバシーポリシーに記載されているとおり、弊社はクッキーおよび類似の技術を含む、お客様と弊社および弊社のウェブサイトとのやり取りから個人情報を収集します。また、弊社は、広告パートナーを含む第三者とこの個人情報を共有する場合があります。これは、お客様の興味により関連性の高い広告を他のウェブサイトに表示するため、および弊社のプライバシーポリシーに概説されているその他の理由のために行われます。

お客様の異なるウェブサイトでのやり取りに基づいたターゲット広告のための個人情報の共有は、特定の米国の州のプライバシー法の下で「販売」、「共有」、または「ターゲット広告」とみなされる場合があります。お住まいの地域によっては、これらの活動をオプトアウトする権利がある場合があります。このオプトアウトの権利を行使したい場合は、以下の指示に従ってください。

Global Privacy Controlのオプトアウト設定シグナルを有効にして弊社のウェブサイトにアクセスした場合、お住まいの場所によっては、これを個人情報の「販売」または「共有」、あるいは弊社のウェブサイトへのアクセスに使用したデバイスおよびブラウザに対するターゲット広告とみなされる可能性のあるその他の使用をオプトアウトするリクエストとして扱います。

CRAFT CLEAR ICE STEP 1

Step 1: Fill the Cup

Add tap water or drinking water to the stainless steel cup until the water reaches the MIN line. Place the cup on a flat surface and avoid filling above the marked line.

CRAFT CLEAR ICE STEP 1

Step 2: Insert the Silicone Mold

Gently place the silicone mold into the cup. Press it down slowly and evenly until it is fully seated. A small amount of water may come out through the vent opening during this step.

CRAFT CLEAR ICE STEP 3

Step 3: Freeze for 16+ Hours

Place the assembled mold upright on a flat surface in the freezer. Freeze for at least 16 hours. A longer freezing time may be needed depending on the freezer temperature and how often the freezer door is opened.

Step 4: Remove the Silicone Mold

Step 4: Remove the Silicone Mold

Take the mold out of the freezer. Hold the stainless steel cup securely and carefully pull the silicone mold out of the cup. Do not twist or force it excessively.

Step 5: Let the Mold Rest

Step 5: Let the Mold Rest

Leave the silicone mold at room temperature for about 2 minutes. This allows the outside of the ice to loosen slightly, making the mold easier to open.

Step 6: Open the Mold

Step 6: Open the Mold

Gently open the silicone mold and remove the clear ice ball. Slight bubbles, minor cloudiness, or a small opening at the bottom of the ice ball may occur and are normal.